The STAYBLOCK™ has been designed and produced in Australia by Fence Line Solutions. This product is ideal for the small farmer with the potental to save time and money when fencing. The stay block system can be used with wood/steel strainers and stays or a combination of both. Click below for a step by step guide to using the STAYBLOCK™ with steel strainers and stays.

Step 1: Drill hole 13mm (1/2”)  approximately 900mm (3 foot)  from ground  Insert a STAYpoint	Step 2: Insert a STAYpoint. Recommended steel stays - 2 inch extra light wall x 3m - 1½ inch  medium wall x 3m

Step 3: Position STAYpoint in drilled hole. (Or use another method to join strainer and stay)	Step 4: Position stay in centre “U” of STAYBLOCK™. Loop wire around strainer and  STAYBLOCK™ (Allow one turn  for every two fence wires – maximum 3 turns)

Step 5: Locate tension wire as pictured above in step 4 (at the base of the neck area). Tension at centre with wire strainers while checking and adjusting wires. Tie off as preferred.

Notes: The Extended Bull Wire Knot (pictured right) or a Spiral Fast is suggested for joining wires. Optional: Lubricating wire at strainer post will make straining easier.

For more information on the STAYBLOCK™ contact:
Fence Line Solutions
Phone: (03) 5755 1334
www.fencelinesolutions.com.au